Sewage backs up into a basement because the basement holds the lowest drains in the house. When the sewer line is blocked or the city sewer is overloaded, wastewater takes the easiest way out, which is usually a basement floor drain, toilet, or shower.

A Blockage in Your Line

The building sewer line carries everything from the house to the street. Grease, wipes, roots, or a sagging or broken section can block it. Water from upstairs sinks, tubs, and toilets then has nowhere to go and comes up at the lowest opening. In a two-family home, both units send water into the same line, so the basement can fill quickly.

Heavy Rain and the City Sewer

Much of the city uses combined sewers that carry rainwater and wastewater together. During intense storms, they can fill faster than they drain. When that happens, water can push back up the line toward homes, especially those with fixtures below street level.

No Backwater Valve

A backwater valve lets water leave the home but helps keep it from flowing back in. Many older homes were built without one. NYC Department of Environmental Protection encourages owners to consider installing one, and the work should be done by a licensed plumber.

What to Do Right Now

Stop using water everywhere in the house, and let anyone in the other unit know. Keep people and pets away from the sewage. Stay clear of wet areas near outlets, the furnace, or the water heater. Do not open a sewer cleanout yourself while the line is full.

If you think the city sewer caused the backup, you can report it to 311.

When wastewater reaches a basement, having the drainage system assessed is safer than continuing to use the plumbing. JPR Plumbing can help at (833) 603-1840. After the repair, keeping an eye on the lowest drains in the house can help prevent a repeat.

Leave a Reply

Your email address will not be published. Required fields are marked *