A water heater usually leaks because a fitting has loosened, the relief or drain valve is worn, or the tank has rusted through with age. Where the water appears tells you a lot about which one it is.

Water at the Top

The cold-water inlet and hot-water outlet connect at the top of the tank. Over time, these fittings can loosen or corrode and drip. That water often runs down the side and pools at the base, so it can look like the tank is leaking when it is not.

Water at the Relief Valve

The temperature and pressure relief valve is a safety device on the top or side of the tank, usually with a pipe running down. If water drips or sprays from it, the valve may be worn, or the tank may be too hot or under too much pressure. Never cap or plug this valve.

Water at the Bottom

The drain valve near the bottom can loosen and drip. A puddle that forms directly under the tank with no other source can mean the tank itself has rusted through. Sediment buildup inside speeds up this kind of corrosion. A leaking tank cannot usually be repaired and needs replacement.

What to Do Right Now

If your building has a central hot water system, report leaks to the super instead.

Once the water is off, the leak’s source can be found and your options explained. For help, call JPR Plumbing at (833) 603-1840. If the heater is near the end of its life, comparing a repair to a new unit can help you choose.

Leave a Reply

Your email address will not be published. Required fields are marked *