A sump pump keeps cycling on and off when the check valve has failed and water drains back into the pit, or when the float switch settings are too close together. A pit that is too small for the pump, very high groundwater, or discharge water flowing back toward the house can cause it too. Frequent short cycles can wear out the motor quickly.
A Bad Check Valve
The check valve on the discharge pipe keeps water from falling back into the pit after the pump shuts off. If it is stuck open or broken, the same water returns and the pump turns on again within seconds. You may hear a thud or rush of water each time it stops.
Float Switch Settings
The float decides when the pump turns on and off. If the on and off points are too close, the pump runs for only a few seconds at a time. A float that is tangled or rubbing against the pit wall can also cause short, frequent cycles.
A Small Pit or High Water Table
A small pit fills quickly, so the pump turns on often. During wet seasons or after storms, groundwater can keep filling the pit for hours. Some cycling in heavy rain is normal, but constant short cycles on dry days point to a problem.
Discharge Water Coming Back
If the discharge pipe empties too close to the foundation, the water may soak right back into the soil and return to the pit. Directing it farther from the house can help.
Unplug the pump before checking the float or pit. Never reach into the pit while it is plugged in.
If the pump keeps cycling, a plumber can work out why it short-cycles before the motor burns out. The same visit can include a look at basement drains and the water heater. Call JPR Plumbing at (833) 603-1840.