A sump pump that keeps cycling on and off every few seconds or minutes usually has a failed check valve, a float switch set too low, a pit that is too small for the pump, or a lot of groundwater coming in. Frequent short cycles wear the motor out faster, so it is worth finding the cause.

Water Flowing Back Into the Pit

The check valve on the discharge pipe should stop pumped water from falling back. If it fails, water drops back into the pit as soon as the pump shuts off. The float rises again, and the pump restarts. Listen for a rush of water right after the pump stops. That is a common clue.

A Float Set Too Close

If the float is adjusted so the pump turns on and off within a small range, the pump will run for only a few seconds at a time. A plumber can adjust the switch or replace it with one better suited to the pit.

A Pit That Is Too Small

A strong pump in a small pit can empty it almost instantly, then turn right back on as water trickles in. Matching the pump, pit, and switch helps it run longer, less often.

A Lot of Groundwater

After long rain or snowmelt, water may enter the pit steadily for days. Frequent cycling during that time can be normal. If it continues long after the ground dries, something else is likely wrong. Water that drains out too close to the foundation can also soak back in and return to the pit.

Keep an eye on the pump’s housing. If it feels very hot or smells like burning, turn it off at the breaker if you can reach it safely and get help.

To stop the constant on-and-off, a plumber can check the valve, float, and pit. Call JPR Plumbing at (833) 603-1840. A healthy pump also depends on clear drain lines around the basement.

Leave a Reply

Your email address will not be published. Required fields are marked *