A leaking toilet is an emergency when water is spreading across the floor, the leak will not stop after you close the valve, water is reaching the ceiling or basement below, or the tank or bowl is cracked. A small, slow drip that stops when you shut the valve can usually wait a day or two.

Leaks at the Base

Water around the base after flushing usually means the wax seal under the toilet has failed. Every flush sends a little water under the flooring. Over time, that can rot the subfloor and stain the ceiling below. Stop using the toilet and close its valve until it is repaired.

Leaks From the Tank

Drips under the tank often come from worn bolts or washers that hold the tank to the bowl. A crack in the tank can leak slowly or suddenly. Either way, close the valve. A cracked tank needs to be replaced.

Leaks at the Supply Line

The hose that runs from the wall valve to the tank can crack, bulge, or loosen. Older hoses can burst under pressure. If water is spraying from this connection, close the valve or the main right away.

Leaks You Cannot Stop

If the valve behind the toilet is stuck or broken and water keeps coming, close the main shutoff. In many East Elmhurst homes, the main is in the basement near the water meter.

A toilet that runs into the bowl wastes water but is not a leak onto the floor. Condensation on a cold tank in humid weather can also drip, but it is not a plumbing failure.

When water is leaving the toilet and spreading, the leak can be stopped and the seal replaced. Call JPR Plumbing at (833) 603-1840. Close the valve behind the toilet while you wait. Smaller toilet problems, like a running tank, can be fixed during an appointment for minor toilet fixes.

Leave a Reply

Your email address will not be published. Required fields are marked *