When a water pipe bursts, shut off the main water valve, open a faucet on the lowest floor to drain the lines, and stay away from water near electrical outlets. Then start drying the space, and keep the water off until the pipe is properly repaired.
Where to Find the Main
The main valve is usually where the water service enters the house, often in a basement, utility room, or crawl space near the meter. A wheel-style handle turns clockwise. A lever turns so it sits across the pipe. If you live in a multi-unit building, the valve may be in a shared space, so contact the super.
Why Draining Helps
Closing the main stops new water, but the pipes are still full. Opening a low faucet lets that water drain out there rather than through the break. If hot water was involved, turn off the water heater as well.
Staying Safe
Water that reaches outlets, cords, or appliances can carry current. Do not wade through it. If the breaker panel is in a dry area, switch off the wet rooms. If not, wait for help.
Drying and Documenting
Remove standing water, pull up wet rugs, and move furniture. Once power is safe, run fans to dry the area within a day or two to reduce mold risk. Take photos of the damage and the broken pipe for insurance.
It is also worth asking why it happened. Pipes can burst from freezing, corrosion, high water pressure, or physical damage. Knowing the cause helps prevent the next one.
Rather than patching the pipe with tape and turning the water back on, arrange a permanent pipe repair. If other pipes are the same age, discussing their condition with a plumber is worthwhile, since one break often means others are close behind. Call JPR Plumbing at (833) 603-1840.