When a sump pump stops working, protect yourself from electrical hazards first, then check the breaker, the outlet, and the float switch. While you arrange a repair, keep an eye on the water level in the pit, reduce the water flowing toward it, and move belongings off the basement floor.
Safety Before Anything Else
If the basement floor is wet or water is close to the pump’s cord, outlet, or the electrical panel, do not go down. Never unplug a pump while standing in water. If the breaker panel is in a dry spot, you can turn off power to the basement from there.
A Short Troubleshooting List
When the area is dry and safe:
- Check for a tripped breaker or ground fault outlet
- Make sure the plug is firmly in the outlet
- Unplug the pump and move the float by hand to see if it is free
- Remove debris from around the intake
Plug the pump back in with dry hands, then pour a bucket of water into the pit. A healthy pump starts, empties the pit, and shuts off.
Buying Time
If it still will not run, use less water in sinks, showers, and laundry that drain toward the pit. Outside, make sure gutters are clear and downspouts point away from the house. Lift boxes, electronics, and furniture onto shelves or carry them upstairs, and photograph any water for insurance.
Planning Ahead
Pumps tend to fail during long storms or power outages, when they are needed most. A battery backup pump or a high-water alarm can give you warning and extra protection next time.
If the pump does not restart, your pump can be brought back into service or replaced. It is also a good time to have the floor drain and pit area evaluated so the basement stays dry. Call JPR Plumbing at (833) 603-1840.