Immediately after a water pipe bursts, close the main water valve, then open a faucet on the lowest floor to drain what is left in the lines. Stay away from water near electrical outlets, and start removing standing water as soon as it is safe.
Close the Main Without Delay
The main shutoff is usually where the water line enters the home, often next to the meter. A round handle turns clockwise. A lever turns a quarter turn so it sits across the pipe. If it is stuck, use steady pressure rather than force so the valve does not snap. If you cannot close it, call for help immediately.
Let the Pipes Drain
Even with the main closed, the pipes still hold water. A cold-water faucet on the lowest level lets that water leave through the sink instead of the break. If the burst involves a hot water line, turn off the water heater too.
Think About Electricity
Do not step into water that may be touching outlets, cords, or appliances. If the breaker panel is in a dry area, switch off the circuits for the wet rooms. If it is not, wait for help.
Start the Cleanup
- Mop and towel up standing water
- Move rugs, furniture, and electronics to dry rooms
- Photograph the damage and the broken pipe for insurance
- Run fans once the power is confirmed safe
Avoid wrapping the pipe in tape and turning the water back on. A temporary patch can fail under full pressure.
When the water is under control, a plumber can install a new length of pipe so service can be restored safely. If other pipes in the home are the same age, having the rest of your water lines looked at can prevent the next break. Call JPR Plumbing at (833) 603-1840 for help with the repair.