Immediately after a pipe bursts, close the water off at the nearest valve or the main, keep everyone away from wet electrical areas, and warn anyone below or beside you. Those three steps in the first few minutes do more to limit damage than anything you do later.
Minute One: Stop the Water
Go straight for the shutoff. If the break is on a fixture line, close that fixture’s valve. If not, close the main or your unit’s shutoff. In many apartment buildings, risers are controlled by building staff, so call the super right away if water keeps coming after you close every valve you can reach.
Minute Two: Check for Electrical Hazards
Look for water near outlets, lamps, power strips, appliances, and the electrical panel. Keep people out of those areas. Only switch off breakers you can reach without standing in water. If water is dripping from a light fixture, leave that light off.
Minute Three: Warn Others
In Elmhurst’s apartment buildings and multifamily houses, water from a burst pipe can reach neighbors within minutes. Knock on the door below and tell the building staff. Early warning lets others move belongings and check their own ceilings.
After That: Start Limiting Damage
- Open a faucet to drain remaining water from the line
- Soak up and remove standing water
- Move furniture, rugs, and electronics to a dry spot
- Take photos before you clean up too much
Do not wrap the pipe with tape and turn the water back on. A temporary patch can fail under full pressure. A plumber can put in new pipe and check it for leaks before water is restored.
If a pipe has just burst, call JPR Plumbing at (833) 603-1840. After the repair, a look at lines in the basement and crawl spaces can show whether others are likely to fail, especially before winter.