If a water pipe bursts, close the main water valve right away, drain what is left in the pipes, and stay clear of any wet electrical areas. Then protect your belongings and get the broken section repaired before using water again.
Close the Main
In most East Elmhurst houses, the main shutoff is in the basement near where the water service enters, usually by the meter. Turn a round handle clockwise until it stops, or turn a lever a quarter turn so it sits across the pipe. Practice finding it now so you are not searching during an emergency.
Drain the Lines
After the main is off, open a cold faucet on the lowest level of the home. That lets water left in the pipes run out through the faucet instead of the break. Flushing toilets once empties their tanks too.
Watch the Basement
Burst pipes often show up in basements, where they can soak stored items and reach the water heater, boiler, or washer. Move what you can off the floor. Do not walk through water near outlets or the electrical panel, and only switch off breakers you can reach from a dry spot.
Start Drying
- Remove standing water with mops, towels, or buckets
- Run fans and open windows when it is safe
- Pull up soaked rugs and move furniture from walls
- Take photos for your records and insurance
Drywall and insulation that stay wet for more than a day or two may need to be removed to prevent mold.
Do not patch the pipe with tape and turn the water back on. A temporary fix can fail under pressure and flood the area again. A plumber can replace the damaged section and test the line.
For help with a burst pipe, call JPR Plumbing at (833) 603-1840. Once the repair holds, a look at other pipes that freeze easily can help you prepare for the next cold snap.