If a pipe bursts, close the water off at the nearest valve or the main shutoff right away. Then keep clear of any wet electrical areas and call a plumber to repair the break.
Find the Right Valve
In a house, the main shutoff is usually where the water line comes in, often in the basement. In a condo or apartment, there is often a shutoff for your unit near the water heater, in a utility closet, or behind an access panel. If you cannot find it within a minute or two, call your building staff. They may need to close a riser valve that serves several floors.
Protect the Space Below
Water from a burst pipe can soak through a floor quickly. If you live above other units, tell your neighbors and the building office right away. Fast warning gives them time to move furniture and electronics.
Stay Clear of Electrical Hazards
Do not walk through water near outlets, power strips, or appliances. Turn off power at the breaker only if you can reach it from a dry spot.
Start the Cleanup
Once the water is off:
- Open a faucet to drain what is left in the line
- Mop up standing water and move wet items
- Take photos before and during cleanup
- Run fans when it is safe to use power
Wet drywall and insulation can hold moisture and grow mold, so they may need to be checked later.
Do not try to tape the pipe and turn the water back on. A temporary patch can fail under full pressure. A plumber can cut out the damaged section and replace it properly, then test the repair before the water goes back on.
If a pipe has burst in your home, call JPR Plumbing at (833) 603-1840. Once the repair holds, a look at pipes in unheated corners can prevent a repeat.