When a sump pump stops removing water, check the pit for debris, listen to how the pump sounds, follow the discharge pipe, and look at where the water exits outside. Do these checks from a dry spot, and leave any work on the pump or its wiring to a professional.
Look and Listen at the Pit
Is the pump running? Is the water level dropping at all? A pit full of mud or gravel can choke the intake screen. A pump that runs smoothly but moves little water may have a clogged intake or a jammed impeller. A loud hum without movement often means the impeller is stuck or the motor is failing. If you smell burning, turn off the breaker if you can reach it safely.
Follow the Pipe
Trace the discharge pipe from the pit. There is usually a check valve a short way up. If water rushes back into the pit when the pump stops, that valve may have failed, and the pump is moving the same water over and over. Look for cracks or loose joints that let water leak back into the basement.
Go Outside
Find where the pipe ends. Make sure it is not:
- Buried under snow, leaves, mulch, or soil
- Crushed by a car, a lawnmower, or foot traffic
- Frozen solid in winter
- Draining right next to the foundation
Water that empties too close to the house can soak back in and return to the pit.
Think About Capacity
An older or undersized pump may run nonstop and still fall behind during heavy rain. If that happens often, a larger pump or a backup may make sense.
If these checks do not reveal the problem, a plumber can test the pump, valve, and line. Call JPR Plumbing at (833) 603-1840. A pump that struggles may also point to drainage problems elsewhere in the basement.