When a sump pump stops removing water, check the intake screen for debris, the discharge line for blockages or ice, the check valve for sticking, and the float for free movement. If all of those look fine, the pump itself may be worn out or too small for the amount of water coming in.

Start With Safety

Unplug the pump before touching it or reaching into the pit. Do not stand in water while handling cords or outlets. If the basement is already flooding, stay out and get help.

Intake and Pit

Look at the bottom of the pump where water enters. Mud, gravel, and small debris can block the screen. Clear what you can see by hand while the pump is unplugged. A pit with a lot of sediment may need to be cleaned out.

Discharge Line and Check Valve

Follow the discharge pipe to where it exits the home. Make sure the outside end is not buried, blocked by leaves, or frozen. Inside, the check valve should let water flow out but not back in. A valve stuck closed stops water from leaving, while one stuck open lets water fall back into the pit.

Float and Pump Size

Make sure the float rises and falls without catching on the pit wall. If everything works but water keeps rising during storms, the pump may not be strong enough for the amount of groundwater. A plumber can help you decide if a larger pump or a backup pump makes sense.

Loud grinding, frequent cycling, or a motor that feels very hot can all mean the pump is failing.

If the problem is not obvious, each part from pit to outlet can be checked. If the basement has other water issues, ask about fixing other water problems down there. Call JPR Plumbing at (833) 603-1840.

Leave a Reply

Your email address will not be published. Required fields are marked *