A sump pump keeps cycling on and off when its check valve lets pumped water fall back into the pit or its float switch works within too narrow a range. It can also happen when the pit is small for the amount of water, groundwater is unusually high, or the discharge water runs back toward the house. Short, frequent cycles can wear out a motor quickly.

The Check Valve

After the pump shuts off, the check valve on the discharge pipe should hold the water in the pipe. When it fails, that water drops back into the pit, raises the level, and starts the pump again. A thump or rush of water each time the pump stops is a common clue.

The Float Setting

The float decides when the pump starts and stops. If the on and off points are too close together, the pump runs for only a few seconds at a time. A float that rubs against the pit wall or is tangled in the cord can cause the same short bursts.

Pit Size and Groundwater

A small pit fills quickly, so the pump turns on more often. During wet seasons or after storms, groundwater can keep the pit filling for hours. Some cycling in heavy rain is expected. Constant short cycling on dry days is not.

Water That Comes Back

If the discharge pipe empties close to the foundation, the water can soak right back into the soil and return to the pit. Extending the discharge farther from the house often helps.

Always unplug the pump before checking the float or reaching into the pit.

If the pump keeps short-cycling, the cause can be diagnosed before the motor burns out. While a plumber is there, extending or rerouting the discharge pipe can be discussed. Call JPR Plumbing at (833) 603-1840.

Leave a Reply

Your email address will not be published. Required fields are marked *