When a pipe bursts, turn off the main water valve immediately, open a faucet on the lowest level to drain the pipes, and stay clear of any water near electrical outlets or appliances. Then remove water as quickly as you can and leave the main off until the pipe has been repaired.
Turning Off the Main
The main valve is usually where the water service enters the home, often beside the meter in a basement or utility area. Round handles turn clockwise. Levers turn a quarter turn so they cross the pipe. If the valve is stiff, use steady pressure so it does not snap. If you cannot close it, call for help right away.
Emptying the Lines
Even with the main closed, water sits in the pipes. Opening a cold faucet on the lowest floor lets it flow out there instead of through the break. Flushing the toilets once helps too. If a hot water line burst, switch off the water heater as well.
Electrical Caution
Water that reaches outlets or power strips can be dangerous. If the breaker panel is in a dry spot, turn off the wet rooms. Otherwise, stay out of the water until help arrives.
Cleanup Basics
- Mop and towel up standing water
- Move furniture, rugs, and valuables to a dry room
- Run fans and open windows once the power is safe
- Photograph the damage for insurance
Drying quickly lowers the chance of mold in walls and floors.
Skip temporary fixes like tape or clamps followed by turning the water back on. They can fail under full pressure and cause a second flood.
Instead of a quick patch, have the broken pipe replaced with a lasting repair. If the burst came from age or corrosion, asking about other pipes of the same vintage is a smart follow-up. Call JPR Plumbing at (833) 603-1840.