When a pipe bursts, go straight to the main water valve and shut it off. Then open a faucet on the lowest level to drain the pipes, keep away from electrical hazards, and start removing water as quickly as possible. Do not turn the water back on until the pipe has been repaired.

Shut Off the Main

The main valve is usually where the water line enters the home, often near the meter. Turn it clockwise until it stops. If it is stiff, use steady pressure rather than force so it does not break. In a building with several units, let the super or other residents know right away.

Drain the System

Even with the main closed, the pipes hold water. Open a cold-water faucet on the lowest floor and flush the toilets. If the burst involves a hot water line, turn off the water heater as well.

Keep Electrical Safety in Mind

Water that reaches outlets, power strips, or appliances can cause shocks. If the panel is in a dry area, switch off power to the wet rooms. If it is not, stay out of the water and wait for help.

Start the Cleanup

Wet drywall and insulation can grow mold within a couple of days, so drying quickly matters.

Avoid patching the pipe and turning the water back on. Temporary fixes can fail under full pressure and cause a second flood. Instead, have the burst section cut out and replaced with new pipe that can handle full pressure. If your home has older pipes, ask about checking the rest of the system after the repair, especially pipes near outside walls or in the basement. Call JPR Plumbing at (833) 603-1840.

Leave a Reply

Your email address will not be published. Required fields are marked *