A water heater usually leaks from one of four places: the pipe connections on top, the temperature and pressure relief valve, the drain valve near the bottom, or the tank itself. Leaks from the first three can often be repaired. A leaking tank usually means the heater needs to be replaced.
Tracing the Water
Look carefully, but do not touch hot pipes or parts. Wipe surfaces dry with a towel, then check where new water appears first. Water that starts at the top and runs down the side often comes from a connection, not the tank. A puddle directly under the center of the tank, with dry sides, suggests the tank has rusted through.
The Relief Valve
This safety valve opens if the tank gets too hot or the pressure gets too high. A steady drip or spray from it means it may be worn, or the heater may need adjustment. Never cap or plug the relief valve or the pipe attached to it.
The Drain Valve
Near the bottom of the tank is a valve used to flush sediment. It can loosen or wear and drip slowly. Sometimes it is simply not closed all the way.
What to Do Now
- Close the cold-water valve on the pipe feeding the heater
- Turn a gas heater to off or pilot, or switch off an electric heater at the breaker
- Keep people away from hot water on the floor
- If you smell gas, leave and call 911 or your gas utility from outside
In some Elmhurst apartment buildings, hot water comes from a central boiler. If your unit has no heater of its own, report any leak to building staff.
Once the water is off, the leak’s location can be pinned down and a fix recommended. Call JPR Plumbing at (833) 603-1840. If the tank itself is leaking, choosing a replacement heater is usually the next step.