When a sump pump stops working, start by making sure the area is safe to approach. Then check the power, the cord, and the float from a dry spot. If the pump still will not run, protect what you can in the basement and get it repaired before the next heavy rain.
Is It Safe to Go Near?
Water, cords, and outlets do not mix. If the floor around the pit is wet, do not step into it. Only touch the breaker panel if you can reach it without standing in water. If you cannot get close safely, wait for help.
Check the Simple Things
From a dry place:
- Make sure the pump is plugged in and the cord is not damaged
- Look for a tripped breaker or GFCI outlet and reset it once
- See whether the float is stuck against the pit wall or caught on the cord
If the breaker trips again, leave it off. That usually means a fault in the pump or wiring.
Listen and Smell
A pump that hums without moving water may have a jammed impeller or a failing motor. A burning smell means the motor may be overheating. Neither is a safe do-it-yourself repair when the pit is full.
Protect the Basement
Move boxes, papers, electronics, and anything stored on the floor up onto shelves or upstairs. In homes where a second household uses the basement, let them know. If the water is shallow and the area is safe, towels and a mop can slow the spread.
Once the pump is fixed, test it by slowly pouring water into the pit. Ask whether a backup pump or high-water alarm would make sense for your home.
When the pump will not restart, it can be rebuilt or replaced and tested with water. Call JPR Plumbing at (833) 603-1840. To avoid surprises, a check of the pump before storm season is a good idea.