If a toilet overflows, cut off its water first. Turn the small valve behind the toilet clockwise, or take the lid off the tank and push the flapper down by hand. Once the water stops rising, clean up and decide whether the clog is something you can safely clear.
Get the Water to Stop
The valve is usually low on the wall or floor behind the toilet. If it will not turn, do not force it, since older valves can break. Lifting the float arm inside the tank also stops the refill. Avoid flushing again until the problem is solved.
Protect the Floor and the Neighbors
Overflow water spreads fast on bathroom tile and can seep into the floor. In co-op and apartment buildings, it may reach the ceiling below within minutes. Lay down towels right away. If a lot of water spilled, let your downstairs neighbor and the super know.
Clean Up With Care
Overflow water can contain waste. Wear gloves, soak up the water with old towels, and bag them. Wash the floor and the base of the toilet with soap and water, then disinfect. Wash your hands well when you are done.
Decide Whether to Plunge
A flange plunger, the kind with an extra rubber sleeve, works best on toilets. A few firm pushes and pulls clear many simple clogs. Stop if water climbs toward the rim. Do not use chemical cleaners in a toilet.
Call a plumber if:
- The toilet still will not drain after a few tries
- A toy, phone, or other object went down
- Water rises in the tub when you flush
- Other drains are slow or gurgling
The last two suggest a clog in a shared line rather than the toilet itself.
For a clog that will not clear, a plumber can open the line and check the toilet. Call JPR Plumbing at (833) 603-1840. If clogs happen often, a review of how your toilets and drains are used can point to the cause.