A sump pump that will not turn on almost always has a problem in one of three places: its power supply, its switch, or its motor. Working through them in that order, from a dry spot, can tell you whether there is a simple fix or whether a plumber is needed.
Part One: Power
A pump cannot run without electricity. Storms, a tripped breaker, a tripped GFCI outlet, or a plug that has worked loose can all cut it off. Check these only if the floor around the pit is dry. One reset is fine. A breaker that trips again right away points to a fault in the pump or wiring, so leave it off.
Part Two: The Switch
The float switch tells the pump to start. It rises as the water rises. If it is wedged against the side of the pit, tangled in the cord, or blocked by debris, it never rises far enough. Some switches also wear out after years of use. From the edge of the pit, you can usually see whether the float looks free.
Keep in mind that many pumps are set to start only once water reaches a certain level. A little water in the bottom of the pit is normal.
Part Three: The Motor
If the pump has power and the float is free but nothing happens, or you hear a hum without any pumping, the motor or impeller may have failed. Motors can burn out after a long storm or after running with no water. This is not a do-it-yourself repair, especially with water in the pit.
While You Sort It Out
Move belongings off the basement floor, and keep away from wet cords and outlets.
When the pump stays silent, a plumber can trace the fault in the switch or motor and get it working. Call JPR Plumbing at (833) 603-1840. To stay ready for storms, a yearly test of the pump and pit is a good habit.