A water heater usually leaks because the tank is aging and rusting, a valve is faulty, or a pipe fitting has worked loose. In homes that have been through flooding, water damage to the heater’s parts can also lead to problems.

Age and Rust

Over time, the inside of a tank can rust, especially once the anode rod, which helps protect it, wears away. Sediment at the bottom of the tank can speed this up. A tank that is leaking from its body usually cannot be repaired and needs to be replaced.

Valve Problems

The temperature and pressure relief valve lets out water if the tank gets too hot or the pressure is too high. If it drips or sprays, the valve may be worn, or the tank may be overheating. The drain valve near the bottom can also loosen and drip. Never cap or plug a relief valve.

Loose Fittings and Flood Damage

The pipes that connect to the top of the tank can loosen over time. Water may drip down the side of the tank and pool at the base, making it look like the tank is leaking.

Parts of Staten Island have dealt with serious flooding during major storms. If a water heater has been sitting in floodwater, its controls, burner, or insulation may be damaged. A heater that has been underwater should be checked by a professional before it is used again.

What to Do Right Now

Close the valve on the cold-water pipe going into the top of the heater. Then shut off its heat source, either the gas control knob or the electric breaker. Stay clear of hot water on the floor. If there is any smell of gas, get everyone outside and call 911 or your gas utility once you are out.

A plumber can find where the heater is leaking and explain your options.

If your water heater is leaking, call JPR Plumbing at (833) 603-1840. For an older tank, a talk about repair versus replacement can help you plan ahead.

Leave a Reply

Your email address will not be published. Required fields are marked *